Material Safety Data Sheet (MSDS)
High Temp Grease - Order No. GR-70
PRODUCT NAME: High Temp Grease
HAZARD MATERIAL ID SYSTEM: H-1
SECTION 1 – DESCRIPTION
| PRODUCT NAME: |
High Temp Grease |
| DOT SHIPPING NAME: |
N/A |
| DOT HAZARD CLASS: |
Non-Hazardous |
| CAS REGISTRY NUMBER: |
N/A |
| CHEMICAL NAME: |
Petroleum Hydrocarbon |
| PREPARER: |
Chip Armstrong, 5-22-88 |
SECTION 2 – HAZARDOUS INGREDIENTS
| COMPONENTS: |
Petroleum hydrocarbon plus trade secret additives |
SECTION 3 – PHYSICAL DATA
| BOILING POINT: DEG F: |
no data available |
| SOLUBILITY IN WATER: |
negligible at 25 DEG C |
| MELTING POINT: DEG F: |
500 |
| APPEARANCE: |
Grease/red |
| VAPOR DENSITY: |
greater than 5 |
| VAPOR PRESSURE: |
less than .01mm HG at 20 DEG C |
| SPECIFIC GRAVITY: |
.9 at 60 DEG F |
| ODOR: |
mineral oil-mild oil |
SECTION 4 – FIRE AND EXPLOSION DATA
| FLASH POINT, DEG F: |
450 COC, lowest oil |
| EXTINGUISHING MEDIUM: |
water fog, foam, dry chemical, carbon dioxide, sand/earth |
| SPECIAL FIRE FIGHTING PROCEDURES: |
Use water spray to cool exposed containers. Fire fighting personnel should use respiratory protection. |
| UNUSUAL FIRE EXPLOSION HAZARDS: |
product of combustion includes fumes, C02, and dense smoke. |
SECTION 5 – REACTIVITY HAZARDS
| STABILITY: |
stable |
| HAZARDOUS POLYMERIZATION: |
will not |
| MATERIAL TO AVOID: |
strong oxidizers |
| CONDITION TO AVOID: |
open flame |
SECTION 6 – HEALTH HAZARD INFORMATION
| ROUTE OF ENTRY: |
Inhalation, Skin, Ingestion |
| ACUTE OVEREXPOSURE: |
may cause reversible eye and skin irritation; prolonged skin exposure may cause dermatitis; ingestion may cause craps & diarrhea; breathing mist may cause dizziness |
| CHRONIC OVEREXPOSURE: |
defined by IARC as class I mineral oil |
| |
|
CHEMICAL LISTED AS CARCINOGEN OR POTENTIAL CARCINOGEN: |
| NATIONAL TOXICOLOGY PROGRAM |
NO |
| IARC MONOGRAPHS |
NO |
| OSHA |
NO |
| |
|
| THRESHOLD LIMIT VALUE: |
5mg/cubic meter as mist |
| |
|
EMERGENCY AND FIRST AID: |
In all cases remove source of exposure
- INHALATION: unlikely to occur except as mist
- EYES: flush with water for at least 15 minutes or until irritation subsides
- SKIN: wash well with soap and water; remove oil soaked clothing; wash cloths before reuse; if irritation develops, consult physician.
- INGESTION: DO NOT induce vomiting; consult physician; contains solvent
|
SECTION 7 – SPECIAL PROTECTION INFORMATION
| RESPIRATORY PROTECTION: |
normally not required with adequate ventilation; if exposure exceeds limits, use NIOSH/MSHA approved air respirator. |
| VENTILATION: |
if mists are present, provide adequate ventilation to control level below the Permissible Exposure Limit. |
| PROTECTIVE GLOVES: |
impermeable gloves |
| EYE PROTECTION: |
goggles |
| OTHER: |
none usually required. |
SECTION 8 – SPECIAL PRECAUTIONS AND SPILL/LEAK PROCEDURES
| HANDLING & STORAGE PRECAUTIONS: |
Keep away from fire, flam & sparks. |
| OTHER PRECAUTIONS: |
Never wear oil soaked clothing; discard oil soaked shoes; affix proper warning labels on containers according to 29 CFR 1010.1200 |
| IN CASE OF SPILLS: |
No unusual hazard; use pump and/or oil absorbent; keep from entering waterways and sewers. |
| WASTE DISPOSAL METHODS: |
Dispose to current local, state and federal regulations; consider recycling: |
| NOTE: |
material may become a hazardous waste through use. |
NOTE: The above information is based on data of which we are aware and is believed to be correct. However, no warranty is expressed or implied regarding the accuracy of this data or the results to be obtained from the use thereof. J. Thomas Distributors assumes no responsibility for injury to vendee or third persons proximately caused by the material if reasonable safety procedures are not adhered to as stipulated in the data sheet. Additionally, we assume no responsibility to vendee or third persons proximately caused by abnormal use of the material even if reasonable safety procedures are followed. Furthermore, vended assumes the risk in his use of the material.