Spreading Radius: 2' to 25'; 12 volt electric start 8.5 HP Briggs & Stratton I/C motor; Clutch control with blast option; Adjustable material deflectors; Electric throttle control; 12" steel spinner; Easily mounts on 3/4 ton or 1 ton trucks; 1.8 cubic yar

Spreading Radius: 2' to 25'; 12 volt electric start 8.5 HP Briggs & Stratton I/C motor; Clutch control with blast option; Adjustable material deflectors; Electric throttle control; 12" steel spinner; Easily mounts on 3/4 ton or 1 ton trucks; 1.8 cubic yar

For 4 cubic yard spreaders

Allows for use with salt or salt/sand mix; Molded polymer unibody spreader with sides sloped at 40* angles to maximize material flow; Screw type auger system travels the length of the hopper floor; Independent spinner/auger controller; Salt: 2.2 cu. Ft./m

Hinged lid with self securing latch; Concealed 80 lb. vibrator; molded hopper handles; 12 volt motor is enclosed in a sealed housing inside the hopper; 10 cubic ft. #1 rock salt; mounts to bumper or 2" receiver hitch

Thermoplastic hopper holds 300 lbs.; Light Commercial Model spreads up to 30' and Residential Model spreads up to 10' - ideal for driveways; In-cab on/off control; Stainless steel spinner and auger; Shipping weight: 66lbs; Includes all mounting hardeware

1" Replacement Spinner Hub for Sand & Salt Spreaders. 1" Shaft, 1/4" keyway, 4 bolt holes

For quick mounting and dis-mounting of our TGS01A and TGS05A tailgate spreaders; Fits most pickup trucks; Replaces 0207005

Thermoplastic hopper holds 600 lbs; Spreads from 3' to 30'; In-cab electronic speed control; Stainless steel spinner and auger; Shipping weight: 135 lbs.; Includes all mounting hardware for step bumper mounting; NOTE: Sand is NOT a recommended material

304 stainless steel; 96" under tailgate spreader; 2 ultra quiet 12 volt DC direct drive motors; Under tailgate mounting allows for normal use of dump body; In-cab controller for both spinner and auger; Includes stainless steel mounting brackets; NO need f

Meyer-Control to Battery Wire (Red), for a Tailgate Spreader

Low profile design allows full rear view from the vehicle; Thermoplastic hopper holds 800 lbs.; Spreads from 3' to 30'; In-cab electronic speed control; Stainless steel hopper throat and spinner; Shipping weight: 165 lbs.; Includes all mounting hardware f

24 Tooth Sand and Salt Spreader Spinner Sprocket

18" Polyurethane Spinner with 4 bolts

1" x 23 1/2" Long Shaft

12 Teeth

Free-up wet, sticky or frozen material in hopper with a flip or switch; 5 amp; 12 volt omtor; 4000 RPM max.; 5 WT; Includes switch and 20' of wire

1" x 35 1/2" Long Shaft

52 tooth

Clutch Sprocket

Uses #40 roller chain

11-3/4" Diameter Poly Spinner with a 3/4" Center Hole

Height - 2"

Use with 1.3-2.3 cubic yard, Universal and Salt Dogg Spreaders

Width - 2 1/4"

3/4 Bore,5" Length,3-3/4 Center to Center Bolt Holes, 3" Height & Zerk fitting on the bottom